MF-E

Description

Sequential shift 6-speed transaxle designed for use in the Mitsubishi Lancer Evolution.

Features

• The MF-E is a complete gearbox, replacing the original Mitsubishi unit between the engine and the transfer case. Two versions will be available. The MF-E9 for use in EVO's IV-IX and the MF-E10 for use in the latest EVO X
• Torque rating for endurance events is 700Nm (520ft.lb).
• The gearbox is fitted with 6 forward gears, a reverse gear set and a ring & pinion. All gears are profile ground for increased efficiency and durability
• All gears have an extensive range of ratios available, the 1st pinion gear is integral with the shaft.
• The centre differential is included and compatible with all EVO 4-9 mechanical and active (ACD, AYC) systems / transfer cases.
• The internal lubrication system consists of a magnetic / paper element filter, an oil pump with provision for an external cooler, a spray bar to feed cooled oil directly onto the gears, through-shaft lubrication to all needle roller bearings and oil feed for the transfer case.
• Output is designed to work with the standard Mitsubishi tripods and drive-shafts. Holinger can supply optional stronger shafts if required.
• The original clutch, slave-cylinder and fork are compatible.
• The original speedometer system is compatible.
• The original front and rear mounts can be used. A new top mount is supplied with the gearbox.
• A stand-alone gear-lever system with an integral shift-cut trigger is available. Holinger can supply a complete floor mounted system with cables to interface with the gearbox.
• A gear position sensor is supplied for interfacing with an electronic dash display. Alternatively a stand-alone gear indicator display is available for cars not fitted with an electronic dash.
• A temperature sensor can be installed on the gearbox (M12x1.5).
• Case hardened nickel chrome steel is used for all gears and shafts.
• The selector forks are manufactured from high tensile, nitrided steel.
• Casings are sandcast Aluminium alloy, heat treated to T6 specifications.
• O-ring seals are used on all joint faces.
• Gearbox weight is 50kg (110lbs).